To make a bat mask:

1. Cut out 'Base Mask' from black card. (Use Halloween Bat Mask Template 1)

2. Cut out 'Bat Head' and two 'Bat Wings' from black foam sheets and two 'Fangs' from white card or foam. (Use Halloween Bat Mask Template 2).

3. Cut out an eye hole in each wing. Join wings in the centre of the mask, making sure the holes are in line, and stick to base mask with double-sided tape.

4. Stick eyes and fangs to face with double-sided tape.

5. Stick Bat Head to mask, just above eye holes.

6. Trim any black card off base mask that is showing.

7. Fold tabs of base mask in half, towards the mask. Fold in half again.

8. Tie elastic to tab and staple (Make sure staple points are away from face).

9. Repeat step 8 for other side.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.