To make a ghost puppet:

1. Glue split pin into polystyrene ball.

2. Take two sheets of white tissue paper and if necessary, remove creases using a hot dry iron. (Only use iron with adult supervision.)

3. Stick two strips of double-sided tape either side of split pin, on polystyrene ball.

4. Lay one sheet tissue paper on table.

5. Remove backing tape from double sided tape. Stick polystyrene ball, split pin face down, in centre of tissue paper.

6. Mould tissue around top of ball.

7. Stick two more strips of double-sided tape either side of split pin.

8. Remove backing tape and mould second sheet of tissue around top of ball.

9. Stick eyes to ghost using double-sided tape.

10. Tear bottom of tissue paper to create 'ragged' effect.

11. Tie piece of beading thread around split pin.

12. Glue 2 lollipop sticks together to make a stick about 17cm long.

13. Tie end of beading thread to lollipop stick.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.