HobbyCraft - Exotic Sari Table Runner


		Click here to print this page
Allow: 1 hr	Level: Beginner	Click here to print this page

Exotic Sari Table Runner

What You Need:

2m red fabric

5m decorative
ribbon

1 x pack of
easy hem

Medium sized
rubber stamp
with leaf design

Fabric paint
- gold

Scissors

Iron

Ruler

Chalk

Small paint
brush

1. Fold the fabric in half lengthways and cut into two pieces.

2. Take one length and make a 1cm hem all way round using iron-on easy hem.

3. Lay runner out on a flat surface with newspaper underneath. Using a ruler, mark points at 10cm intervals along the fabric runner and about 5cm in from the edges.

4. With a paint brush, coat the rubber stamp with a thin layer of gold fabric paint and press onto a starting point on the fabric runner. Rotate the stamp 180 degrees and repeat at the next point. Repeat until all sides of the runner are printed.

5. When dry, iron the runner to fix the fabric paint.

6. Cut lengths of ribbon to trim the edges of the fabric runner and secure in place with iron-on easy hem.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.