HobbyCraft - Bride & Groom Chair Decorations


		Click here to print this page
Allow: 1 hr	Level: Beginner	Click here to print this page

Bride & Groom Chair Decorations

What You Need:

Assorted artificial flower heads

6mm & 15mm
wide ribbon

Coloured card

Miniature
paper rose

Pen

Glue gun and
glue sticks

Needle & thread

Metallic pen

1. Remove the stems from the flowers and glue the flower heads along a length of 15mm wide ribbon. This will run along the top of the chair covers on the bride and groom's chairs. When dry, stitch in place.

2. Cut two 3cm x 6cm pieces of card and punch a hole in the top left corner of each. Write 'Bride' on one card and 'Groom' on the other using a metallic pen.

3. Remove the stems from a couple of miniature paper roses and glue a flower head to each name card.

3. Attach each card around a flower head with a length of 6mm wide ribbon.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.