HobbyCraft - Bride & Groom Chair Posies


		Click here to print this page
Allow: 1 hr	Level: Beginner	Click here to print this page

Bride & Groom Chair Posies

What You Need:

15mm ribbon

5mm ribbon

Floral stems

Florists wire

Coloured card

Pen

Hole punch

Wire cutters

1. Make two small posies using a selection of floral stems and secure in place with wire.

2. Cut two 3cm x 6cm pieces of card and punch a hole in the top left corner of each. Write 'Bride' on one card and 'Groom' on the other using a metallic pen. Tie onto the posy with a long length of 5mm wide ribbon.

3. Starting from the bottom, wind the remainder of the ribbon around the stems, covering the wire and finishing with a bow.

4. Tie a length of 15mm ribbon around the back of each chair and attach the posies in place.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.