HobbyCraft - Brides Floral Bouquet


		Click here to print this page
Allow: 1 hr	Level: Beginner	Click here to print this page

Brides Floral Bouquet

What You Need:

Selection
of artificial
floral stems

Crystal effect
beads on wire

Organza
bomboniere
tulles

15mm wide
ribbon

Double sided
tape

Pearl head
pins

Wire

Wire cutters

1. Remove leaves from your chosen flowers and bunch together to form a large round posy. Tie wire around flower stems to secure them in place.

2. Poke crystal effect beads on wire inside a few of the flower heads and glue in place.

3. Place foliage around base of posy, and again secure in place by binding stems with wire.

4. Place a layer of organza bomboniere tulles around the base of the posy and again secure in place with wire.

5. Trim flower stems to required length. Wrap a length of 15mm wide ribbon around the majority of the length of the stems (covering the wire) and securing in place with double sided tape and pearl head pins. Finish with a large bow beneath the head of the posy.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.