HobbyCraft - Pew End


		Click here to print this page
Allow: 1 hr	Level: Beginner	Click here to print this page

Pew End

What You Need:

Selection of
artificial floral
stems and
leaf foliage

Feather picks

Dry floral foam

Galvanised
bucket

15mm wide
ribbon

Selection of
seed beads
and sequins

Wire

Wire cutters

Scissors

1. Place a dry floral foam ball inside the bucket.

2. Cut flower stems down to 15cm in length and remove any leaves.

3. Make an arrangement with the flowers and feathers, filling in the gaps with foliage stems cut to 15cm in length.

4. Thread three 25cm lengths of wire with beads and sequins. Bend each wire into a loop and twist together to secure beads and sequins in place, leaving enough wire to poke into the floral foam. Add the finished loops into your arrangement.

5. Tie a length of 15mm wide ribbon to the loop on the bucket, and attach to the end of the pew or seating, finishing with a large bow.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.