2. Iron the 10cm wide sheer ribbon on to heat 'n' bond using a pressing cloth. Cut the ribbon across the middle and trim off the selvedges.
3. Lining the edges up with the lines, overlap the ribbon pieces and iron on to the marked print fabric.
4. Draw out the hearts on heat 'n' bond and iron on to different silver ribbons using a pressing cloth. Cut out and peel off the backing paper. Position on the prepared panel and press.
5. Thread a needle that will go through the beads with a double length of fine braid. Pick up five or six beads and lay along the first marked line. Couch the braid down with silver thread, spacing the beads. Use the picture as a guide.
6. Complete all the vertical lines in the same way. Stick the wadding on to the card. Lay the completed fabric panel centrally on the wadding and stretch over the card using thread or tape to secure on the reverse.
7. Wrap a piece of silver ribbon around the centre of the box lid. Stick the panel in position in the centre of the lid. Use the picture as a guide.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
