1. Cut two 1 metre lengths of beading wire and join them together by tying a large knot at one end.
2. Thread a beading needle on each end and thread them both through the hole in the callotte. Close the callotte tightly over the knot.
3. Thread one each of your three selected types of beads onto both wires.
4. Thread approximately twenty small beads onto each of the wires. Thread the same three original styles of beads onto one of the wires then thread the other wire through from the opposite direction, forming a loop.
5. Continue step 4 until the belt is the required length. Finish the belt with three beads threaded onto both wires.
6. Thread both wires through the hole in the callotte. Tie a large knot to secure and squeeze the callotte tightly over the knot.
7. Add a clasp at either end of the belt by taking the loop on the callotte through the loop on the clasp.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
