HobbyCraft - Funky Door Hanger 'My Room'


		Click here to print this page
Allow: 1 hr	Level: Beginner	Click here to print this page

Funky Door Hanger 'My Room'

What You Need:

Fab foam - assorted colours

PVA glue

Hole punch

Marker pen

Ribbon

Scissors

Pencil

1. Cut a rectangle out of foam. You may wish to cut two to make a double thickness hanger, sticking both pieces together with glue.

2. Use a hole punch to create a hole in the top left and top right corners of the foam rectangles.

3. Draw shapes and letters onto foam and carefully cut them out with scissors. Glue them in position on the door hanger.

4. Use a marker pen to create extra detail.

5. Thread a length of ribbon through the two holes at the top of the hanger and cut it to the required length. Secure in place on the back, with a simple knot on each side.

Tip: Use a pre-cut foam door hanger for a different look.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.