HobbyCraft - Beaded Star Card


		Click here to print this page
Allow: 30 mins	Level: Intermediate	Click here to print this page

Beaded Star Card

What You Need:

Card blanks

Assorted beads

White thread

Needle

Fancy-edged scissors

Craft Mount

1. Use a pencil to draw a star shape on the reverse side of a piece of coloured card.

2. Thread a needle with double thickness of thread and knot the ends together. Insert the needle from back of card through the centre of the star and bring it out to the right side. Thread on a large bead then take the needle back through to the wrong side. Pull the bead up close to the card.

3. Pass the needle through to the front of the card again and thread on your chosen beads to form a point of the star. Thread the needle to the back of the card at the end of the point and secure the thread with tape.

4. Repeat this process for each of the points until you have a beaded star shape.

5. When the star is complete, trim around the edges of the card with fancy-edged scissors.

6. Mount the beaded card on to a white card blank using Craft Mount.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.