HobbyCraft - Tribal Headress


		Click here to print this page
Allow: 30 mins	Level: Beginner	Click here to print this page

Tribal Headress

What You Need:

Fab foam

Chenille stems

Pom-poms

Ribbon

Fur

Feathers

PVA glue

Scissors

1. Cut a strip of fab foam approx. 4cm wide. Cut out a semi-circle shape of fur.

2. Find the middle of the foam strip and with an overlap, glue the fur to the back. Allow to dry.

3. Glue small feathers of marabou trim to the curved edge of the fur and allow to dry.

4. Glue a chenille stem to the top and bottom edge of the foam strip and add pom-poms in between to decorate.

5. Position the large feathers evenly for the top of the headress and glue them in place to the back of the fur. Leave to dry.

6. Carefully cut a slit at each end of the foam. Thread a length of ribbon through both slits to form an adjustable headband.

7. To wear the headress, tie the ribbon in a bow. Use different colours and products such as acrylic gems to create different effects.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.