1. Thread assorted beads onto a number of head pins. Arrange the head pins so that the longest one lies in the centre. Trim the ends of the head pins with wire cutters to create a graduated effect. Use round nose pliers to form a loop at the ends.
2. Cut a length of tiger tail and thread on one end of the bolt ring clasp, securing in place with a crimp bead.
3. Thread a sequence of beads onto a third of the tiger tail. Add the shortest head pin, then a larger bead to hold it in place. Continue adding the head pins in length order until you reach the central, then decrease in size. Complete the necklace with the same bead sequence.
4. Finish by adding the other end of the bolt ring clasp and secure with a crimp bead.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
