Cut the holographic paper into 60 x 130mm strips. Using the Craft Mount stick the strips centrally down the front of the card blanks, lining up the top edges.
*Using a computer print the names of the bride and groom six times onto white translucent Exotic paper, spacing the pairs of names evenly in three columns. Using a ruler to help you, tear the printed-paper into six strips (5 x 12.5cm), making sure the names stay central on each strip.
Lay the printed strips on top of the holographic strips, lining up the top edges and stick in place near the top edge only, using Glue Dots.
Open the cards out flat and mark two hole-positions on the printed strip, 15mm down from the top edge for the ribbon bows and make the holes.
Thread a length of ribbon through the holes and tie ends into a bow.
Decorate the white strip with peel off heart motifs.
* Note: If you do not own a computer use Making Memories Creative sticky silver letters or handwrite with a 0.7mm Silver Gel pen.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
