Decide on a length for your necklace and cut a piece of tiger tail.
Layout your necklace design using assorted beads, with a pendant in the centre.
Use flat nose pliers to open a jump ring and thread it onto the pendant.
Thread one end of the tiger tail through a crimp bead and a trigger clasp then thread it back through the crimp bead. Push the crimp bead close to the clasp and squeeze it with flat nose pliers to hold it in place.
Thread your sequence of beads onto the tiger tail, adding the pendant at the central point.
When all the beads have been added, thread on a crimp bead and the other end of the clasp. Squeeze the crimp bead with flat nose pliers to secure. Trim both ends of tiger tail.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
