HobbyCraft - Felt Pencil Case


		Click here to print this page
Allow: 15 mins	Level: Beginner	Click here to print this page

Felt Pencil Case

What You Need:

Patterned felt

Brads

Eyelet punch or tapestry needle

Cut an A4 piece of patterned felt in half lengthways.

Cut one piece 22cm long and the other 30 cm long.

Draw lines with a pencil on the reverse of one end of the longer piece to taper one end. Trim both sides to form the flap of the pencil case.

Cut a strip of felt 10cm x 3cm.

Place the two larger pieces of felt together and insert brads at each corner to anchor. It may be easier to punch very small holes with an eyelet punch or tapestry needle first.

Attach the strip of felt approx 3.5cm from the top edge of the front of the pencil case and secure with two brads at either side.

Inserts brads every 2cm along the side edges and every 1cm across the bottom.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.