HobbyCraft - Felt Stocking Card


		Click here to print this page
Allow: 15 mins	Level: Beginner	Click here to print this page

Felt Stocking Card

What You Need:

Card blank

Coloured cord

Ribbon

Felt

Mini pegs

Tacky glue

Scotch tape

Double-sided tape

Cut out two or three stocking shapes from felt. Cut the same number of rectangle shapes for the top of each stocking.

Glue the rectangles of felt onto the top end of each stocking using tacky glue. Leave to dry.

Cut lengths of cord the same width as the stockings and glue as stripes on the stockings using tacky glue. Leave to dry.

Cut a length of ribbon or cord about 2cm longer than the width of the card blank. Arrange the ribbon on the front of the card blank, towards the top. Fold either end of the ribbon/cord inside the card blank and secure on the inside of the front of the card blank using scotch tape.

Peg the finished stockings along the length of ribbon/cord.

To cover up the ribbon ends on the inside of the card, cut a piece of card the same size as the front of the card and secure it inside the card using double sided tape.

The information contained within this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Product quantities and selections may vary at each HobbyCraft Superstore. Products are subject to availability and not all ranges are available in all stores. Before making a special journey please contact the store direct to check that they have your required product in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions. Since we have no control over physical conditions surrounding the application of the information herein contained, HobbyCraft Group Ltd disclaims any liability for untoward results.