Cut a length of tiger tail and thread a crimp bead and a jump ring onto one end. Loop the tiger tail over the jump ring and back through the crimp bead and pinch with pliers.
Lay out a pattern of beads for the necklace, using the picture as a guide. Thread the beads onto the tiger tail until reaching the central point.
Thread four small beads then repeat the design for the other half of the necklace.
Finish by adding a crimp bead and a jump ring. Loop the tiger tail back through the jump ring and secure by pinching the crimp bead. Open jump rings at either end and attach a trigger clasp. Close the jump rings with pliers.
To make the pendant, thread beads onto an eyepin. Close the eyepin by making another loop at the end. Attach two jump rings then add the pendant on to the central point of the necklace. Close the jump ring to secure.
Earrings
Follow instructions for making the necklace pendant.
Attach the jump ring to the loop of a long ball wire earring finding.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
