Earrings Take a selection of beads from the Elements Bead box (small wood and stone type) and two bone batik cylinders, thread them on to eyepins so that you have two the same. Use the pliers to turn over the ends on the eyepins to prevent the beads from falling off and then attach each eyepin to a long ball wire. Take a selection of beads from the Elements Bead box (including a few large wooden cube beads); thread them on to eyepins so that you have two the same. Use the pliers to turn over the ends on the eyepins to prevent the beads from falling off, then attach each eyepin to a long ball wire. Bracelet Take a selection of beads from the Elements Bead box and a length of the elastic/thread (which is included), long enough to go round your wrist comfortably. Thread the beads on to the elastic/thread then tie the two ends together. Repeat step 1, but instead of tying the thread ends together, attach (tie) each one on to a clasp fastener instead. Necklace Take eleven eyepins, thread five of them with bone batik cylinder beads and two or three small beads from the elements box. Thread the remaining eyepins with various beads and turn over the ends on all of them to stop the beads from falling off.  On to a length of 1mm bead thonging, thread the beaded eyepins, spacing them using large beads from the elements box so that it is symmetrical. To fasten the necklace tie clasps on to the end of the thonging. Take one eyepin and thread it with various beads including a large flat one. On a length of the elastic/thread included, place the eyepin centrally and on to each side of the eyepin (elastic) thread various beads so that the design in symmetrical. To fasten the necklace tie a clasp on to each end of the elastic/thread.