Cut two required lengths of thin ribbon for a pendant necklace.
Thread two eyepins with beads and twist tops with pliers to form loops.
Thread the eyepins and a charm onto a jump ring using pliers, then thread onto the ribbon.
Thread beads loosely onto each strand of ribbon.
Pair up the ribbon ends, make a loop and thread a large bead on, securing in place with strong glue.
Use pliers to attach a jump ring to each loop, followed by a bolt ring clasp.
Bracelet:
Thread beads onto eyepins and twist top with pliers to form a loop.
String 2 eyepins and one small bead onto desired length of elastic cord. Repeat until all eyepins are strung, adding charms at intervals.
To finish off, thread a large bead onto one end of the elastic cord. Tie ends together and trim. Secure bead in place over knot with strong glue.
Earrings:
Thread four eyepins with beads and twist tops with pliers to form loops.
Thread two eyepins and a charm onto a jump ring.
Use pliers to attach the jump rings to a pair of earrings.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
