Cut the required lengths of beading thread for a three-tiered necklace. At one end of each length create a loop and secure with a crimp, squeezing tight with pliers.
Thread each length with buttons and beads at regular intervals, knotting after each.
Create another loop at each end and secure with a crimp as before.
Using pliers, thread the loops onto a clasp.
Bracelet:
Cut the required lengths of beading thread for a three-tiered bracelet. At one end of each length create a loop and secure with a crimp, squeezing tight with pliers.
Thread each length with buttons and beads at regular intervals, knotting after each.
Create another loop at each end and secure with a crimp as before.
Using pliers, thread the loops onto a clasp.
Earrings:
Thread a button onto the centre point of a 15cm length of beading wire and tie in place.
Holding the two ends together, thread three beads onto the beading wire.
Secure the ends with a crimp and trim excess wire.
Attach to an earring.
The
information contained within this project sheet is presented in good faith,
but no warranty is given, nor results guaranteed. Product quantities and selections
may vary at each HobbyCraft Superstore. Products are subject to availability
and not all ranges are available in all stores. Before making a special journey
please contact the store direct to check that they have your required product
in stock. HobbyCraft Group Ltd disclaims all liability from any injury to anyone
undertaking the construction of this project as a result of improper safety
precautions. Since we have no control over physical conditions surrounding the
application of the information herein contained, HobbyCraft Group Ltd disclaims
any liability for untoward results.
