Skip to Content (Press Enter) Skip to Footer (Press Enter)

How to Make Pyrography Coat Hangers

Level
Beginner
Time
1 hour
Budget
10 - 30

Say something special to your loved one every day, by writing a fun little message that will make them smile on some coat hangers! You can use a pyrography tool to burn a design into any wooden hanger, and make them think of you when they look at their clothes in the morning!

Tutorial by Rachel Richardson.

You will need

Is $ 8.49

Quantity: 1

Subtotal

Is $ 8.49

Is $ 4.49

Quantity: 1

Subtotal

Is $ 4.49

Is $ 15.00 , was $ 22.00

Quantity: 1

Subtotal

Is $ 15.00 , was $ 22.00

You’ve viewed 2 of 3 products

Total:

How to make

You will also need:

Mechanical pencil

Wooden hangers

Design software

Step 1

Measure the hangers, when you create a design allow 8mm minimum around the edge to ensure it fits. The font shown is Bite_Bullet, you can find free fonts available with a quick internet search.

Step 2

Once you have your chosen words, print onto tracing paper and tape onto the hanger. Use the embossing tool to etch the words into the wood, then go over with the pencil.

photo-bb-edit.jpg?sw=680&q=85
Step 3

While allowing the pyrography tool to heat up for approximately five minutes, you can prepare the remaining hangers

Step 4

Begin to burn the design into the wood, following your tracing. For best results use a fine pyroghraphy tip.

photo-cc-edit.jpg?sw=680&q=85
Step 5

You can use a sharp scalpel to gently scratch away mistakes or scorch marks.

Related Products

  • bvseo_sdk, dw_cartridge, 18.2.0, p_sdk_3.2.0
  • CLOUD, getReviews, 19ms
  • reviews, product
  • bvseo-msg: Unsuccessful GET. status = 'ERROR', msg = 'Not Found.'; Unsuccessful GET. status = 'ERROR', msg = 'Not Found.';
Top