3 Simple Mother's Day Cards to Make
Give your mum a Mother's Day card that is as unique as she is.
These three simple designs are all you need to create a fantastic handmade masterpiece that your mum will love.
You will be amazed at the effect just a few materials can have when combined together to create stunning designs, with touching sentiments that will make the day that more memorable.
Project and instructions by Jackie Jasper
You will need
Subtotal
Is $ 1.49
Subtotal
Is $ 4.49
Subtotal
Is $ 6.49
Subtotal
Is $ 12.00
Out of stock
How to make
* White Cards and Envelopes A6 6 Pack
* Mini Alphabet Wooden Stamp Set 30 Pieces
* Assorted 3D Paper Flowers 12 Pack
* A Small Length of Thread
* Black Fine Liner Pen
* Black Ink Pad
* Peach Coloured Card
* Hand Block Font Alphabet Stamps 28 Pack
* Pastel Card A4 10 Pack
* White Card
Step One: Stamp out the sentiment in the bottom right corner. Then, draw a black line all the way around the front of a top folding 6x6” white card blank; add a few squiggly lines here and there.
Hand draw the antenna toward the top centre.
Step Two: Use the template to draw and cut out seven butterflies in rainbow colours and white.
Step Three: Starting with the purple butterfly, fold it in half then glue at the fold only, and fix to the centre of the card front then allow this to dry.
Repeat with all the other colours finishing with the white.
Step One: Draw a line all the way around the edge of an A6 white card blank, then add a few dash lines here and there. Don’t worry if the line is a bit wobbly, it will add to the effect.
Step Two: Stamp out the sentiment in the bottom left corner using black ink.
Step Three: Draw three stems with leaves, then add a paper flower to each stem.
Step One: Cover the entire front of an A6 card blank with peach coloured card.
Step Two: Attach a panel of white card to the card blank using 3d foam pads. Make the panel approximately 1 cm smaller than the card base.
Draw a few stems using a black fine liner.
Step Three: Use the template to draw and cut out the vase shape, stamp out the sentiment onto kraft card then trim into a tag shape and make a small hole in the end. Attach this around the vase using thread secured on the reverse with some tape.
Fix the vase to the card front using more 3d foam pads.
Step Four: Add a flower to each stem to finish.
Related Products
